Darex V-390 User Manual download pdf (Page 13)

Wheel too high Correct Wheel too low

Split Angle Adjustment:

If the chisel angle of the drill has changed due to the relief ground

on the drill, then the point split rotational angle may need to be

changed. To adjust the split rotational angle, loosen the thumb-

screw, (See Picture #19) located on the point split port. Move the

bracket slightly to the left of the alignment detent (See Illustration

20) This will increase the split angle that is required if the relief has

been increased. Move the bracket to the right, counterclockwise, if

the relief has been reduced. The key to this process is to intersect

or remove the chisel line when splitting the drill point. (See Illus-

tration 21a & 21b located at bottom this page)

Center Split Adjustment:

The drill is split using the top edge of the grinding wheel. Because

the grinding wheel is seated on a hub, to correct the centering of

the split, you must raise or lower

the edge of the wheel by adjust-

ing the wheel hub height. After a wheel change, grind a drill and

split the drill. If the center of the split is incorrect (See Illustration

#21) the height of the wheel hub will need to be adjusted.

x UNPLUG machine and remove wheel guard cover (See Picture

#22)

x Remove the exhaust vent located on the left side of the

machine. (See Picture #23)

x A 5/32 Allen set-screw is located on the side of the wheel hub.

(See Picture #24)

x Using a 5/32 T-Handle Allen wrench, loosen the set-screw.

(counterclockwise)

x Raise or lower the hub to correct the split. Moving the wheel

hub a small amount will change the centering of the split sig-

nificantly.

(Illustration C of 21) - Under split: When the top edge of the grind-

ing wheel is too low, the split will NOT come to center.

Raise the wheel hub height.

(Illustration B of 21) - Over split: When the top edge of the grind-

ing wheel is too high, the split will move past center.

Lower the wheel hub height.

Tighten the

5/32 set-screw, replace the exhaust vent and replace

wheel cover.

Sharpen and split drill. Repeat adjustment as needed.

Thumbscrew

Detent

Pic 19

Ill 21a

Ill 21b

Pic 23

Pic 22

Hub Height

set-screw

Pic 24

Illustration B Illustration C Illustration 21

Ill 20

Ill 21b

Ill 21a

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Darex V-390 User Manual Page 13

Comments to this Manuals

Related products and manuals for Power tools Darex V-390